Mechanical Measurements And Metrology Lab Manual Vtu
Subject Code 15MEL 37B / 47B IA Marks 20 Number of Lecture Hours/Week 01 Exam Marks 80 No of Practical Hours / Week 02 Exam Hours 3 CREDITS – 02 COURSE OBJECTIVES. To illustrate the theoretical concepts taught in Mechanical Measurements & Metrology through experiments. To illustrate the use of various measuring tools measuring techniques.
2018-9-13 Read and Download Mechanical Measurements And Metrology Lab Manual Vtu Free Ebooks in PDF format MECHANICAL MEASUREMENTS MICROMETERS - SLIDE GAUGES AND CALIPERS - PRINCIPLES. Mechanical measurement and metrology lab manual vtu PDF may not make exciting reading, but mechanical measurement and metrology lab manual vtu is packed with valuable instructions, information and warnings.
To understand calibration techniques of various measuring devices. COURSE OUTCOMES At the end of the course, the students will be able to Course Outcomes CL POs CO 1 To calibrate pressure gauge, thermocouple, LVDT, load cell, micrometer. U PO1, PO6 CO 2 To measure angle using Sine Center/ Sine Bar/ Bevel Protractor, alignment using Autocollimator/ Roller set. U PO1, PO6 CO 3 To demonstrate measurements using Optical Projector/Tool maker microscope, Optical flats. U PO1, PO6 CO 4 To measure cutting tool forces using Lathe/Drill tool dynamometer.
U PO1, PO6 CO 5 To measure Screw thread parameters using 2-Wire or 3-Wire method, gear tooth profile using gear tooth vernier/Gear tooth micrometer. U PO1, PO6 To measure surface roughness using Tally Surf/ Mechanical Comparator. U PO1, PO6 PART-A: MECHANICAL MEASUREMENTS. Calibration of Pressure Gauge. Calibration of Thermocouple. Calibration of LVDT. Calibration of Load cell.
Determination of modulus of elasticity of a mild steel specimen using strain gauges. PART-B: METROLOGY. Measurements using Optical Projector / Toolmaker Microscope. Measurement of angle using Sine Center / Sine bar / bevel protractor.
Measurement of alignment using Autocollimator / Roller set. Measurement of cutting tool forces using a) Lathe tool Dynamometer OR b) Drill tool Dynamometer. Measurements of Screw thread Parameters using two wire or Three-wire methods.
Mechanical Measurements And Metrology Lab Manual Vtu Pdf
Measurements of Surface roughness, Using Tally Surf/Mechanical Comparator. Measurement of gear tooth profile using gear tooth Vernier /Gear tooth micrometer. Calibration of Micrometer using slip gauges. Measurement using Optical Flats Scheme of Examination:. ONE question from part -A: 25 Marks. Type c relief valve manual.
ONE question from part -B: 40 Marks. Viva -Voice: 15. Marks Total: 80 Marks For more information about all VTU updates please stay connected to us on FB and don’t hesitate to ask any questions in the comment.